RichAuto S & T Co., Ltd
Add: 5th
floor, No.4 building, No 4. Yard, life Rd, life science park, beiqing St., changping district Beijing, China
Tel
：
010-53275118 Fax
：
010-53275110/53275111 Web site
27
2.
Table Size
:
RichAuto
system make the table size as the soft limit values, in order to
prevent machine move over travel
，
machine size must be less than or equal to the
value of the actual motion displacement machine.
Setting
：
Enter “
Table Size
”
，
press “
”/“
” to move cursor to where users
want to modify.Press “
”
，
input the new number
，
press “
” to save
，
cursor
auto move to next line
，
the same operation to change,press “
” to save all value.
3.
Spindle Setup
：
Spindle delay
：
Unit
：
ms;including start delay and stop delay.
Spindle state
：
Used to set system using multi-speed or only on/off 2 status, the
corresponding system parameters. System default “3-line 8-state”, if users need
“1-line 2-state(On/Off)”, users can change the number of lines is 1; See detailed
settings at
J7
spindle output wiring.
4.
Home Setup
：
Home speed
：
Every axis movement speed when back home,system default
speed X.Y: 3000 MM/Minute, Z: 1800 MM/Minute.
Home order
：
Every axis movement order when back home
Including
：
Z,X and Y Z,X,Y Z,Y,X
Z only X and Y,Z X,Y,Z
Y,X,Z XY home X,Y home
Y,X home None home X home only XZ and Y
Home direction
：
Every axis movement direction when back home,this dirction
depends on the position where home switch is on the machine.If home switch
installed in the positive direction,so home direction should be “
positive
” ,and vice
