Rice Lake DIGI DS-520, Руководство по эксплуатации

Страница: 6 / 14

5
3.0. INSTALLATION
This section provides the information required for installing this weighing system
for operation. The following steps accomplish installation.
1. Unpacking
2. Set-up Procedure
3.1. Unpacking
Each component of the DS-520 system is packed in a specially designed carton.
Remove each component from its carton, separate the component from its
polystyrene shell assembly and set aside. Inspect the carton interior to be sure
that all accessories have been removed from the carton. Inspect the carton inner
panels for accessories.
NOTE: Be sure to repack all materials within the carton set. Store the cartons in a secure area so they
can be available whenever future shipment of the scale is required.
3.2. Inspection
Immediately after unpacking, a visual inspection of the scale should be performed.
If any damage has been incurred during transportation notify the shipper and Rice Lake
Weighing systems immediately. Instructions for assessment of damage and further
procedures will then be determined.
3.3. Repackaging
If, at anytime, the DS-520 weighing scale must be returned for modification,
calibration, or repair, be sure that it is properly packed with sufficient cushioning
materials. Whenever possible, the original carton assembly should be retained for
this purpose. Any damage caused by improper packaging will not be covered by
warranty.
3.4. Unlocking Procedure
The unlocking procedure is included on the next page. The DS-520 should
be properly locked whenever it is being transported. See next page for un-locking
procedure.
NOTES:
• Remove 4 M6 screws and lock bracket as shown on page 6. Also check the overload stop. Ensure
that nut is screwed tightly.
•
Locking procedure should include tightening nut until it fully stops.