Rice Lake BenchPro BP-P, Руководство по эксплуатации

Страница: 12 / 32

BenchPro Postal BP-P Scale
8 Visit our website www.RiceLake.com
4.2.2 Configure Service Parameters
To navigate the service setting menu:
• Press to scroll through the parameters and settings
• Press to select a parameter
• Press to return to the previous parameter
• Once all parameters have been set, navigate to the done parameter and press to confirm and save settings
Figure 4-2. Service Menu Parameters
Parameter Description

Semi Automatic Zero Set – The percentage of the scale capacity which can be zeroed from the scale when the zero key is pressed;
Settings: 2% , 5%, 10%, 20%

Initial Power up Zero Setting – The percentage of the scale capacity that can be zeroed from the scale on power up; Settings: 10% , 20%, 50%

Zero Indication – settings: OFF , ON

Automatic Zero Tracking – Automatically zeroes the scale if scale does not return to zero; The zero tracking is ± the display division,
multiplied by the selected setting, but cannot exceed the semi-automatic zero set; Settings: 0.25 d , 0.5 d, 1 d, 2 d, 3 d

Filter – Minimizes the effect mechanical vibration (near the scale) can have on scale readings; The selected setting has a direct correlation to
the display update rate; Settings:
• Med - normal filtering, average update rate
• Hi - more filtering, slower update rate
• Lo - less filtering, faster update rate

Manufacturing mode only; Do not use; Do not adjust; Settings: OFF , ON

Auto Off (only applies to battery powered BP-P 12 x 14 scale) – Select amount of time of inactivity after which scale automatically powers off; Settings:
• Off 1 – off after 1 minute of no use
• Off 3 – off after 3 minutes of no use
• Off 5 – off after 5 minutes of no use
• Off 30 – off after 30 seconds of no use
• Off – scale does not turn off
NOTE:

configured earlier.
Table 4-2. Service Menu Parameter Settings
]HURE SX]HUR ]LQG D]W IL/W $R)) 3URW 3UWRYW %DXG EDK/ HGQRG
3DU 6WRS WDUH *UDY VY &DS &D/ GLDJ GRQH VS/LW XPLWV
]3FW
3FW
3FW
3FW
3FW
3FW
3FW 2II
2Q G
G
G
G
G
UQ*
LQWY/
UQ*
LQWY/
2II
2Q
Q2QH
HYHQ
2GG
Q2QH
2Q
2II P2
<HV
+L
/R 2Q
2II QHG
2II
2II
2II
2II
2II DYWR
2II
2Q
QFL
$YWR
VQD
$YWR
3ULQW
YY/I
YY
/I
/IYY
/)YY/I
/I/I
/I
2II
2Q
/E /E2] 2] K* *U
/E
K* &=HUR
&VSDQ
&/LQ
UDQ
U2Q
GLY$
GLY2
Appears if
3URW
is set to $YWR ,
$YWR or 3ULQW
2II
2Q 2Q
2)) 2II
2Q 2Q
2II 2II
2Q
The lb model of the BenchPro Postal scale a has default unit of
measurements is lb:oz. The kg model of the BenchPro Postal
scale has a default unit of measure of kg. All default units of
measurement are set to On by default while all of the non-default
unit of measurement settings are set to Off by default.