4.3- Handle Assembly (Fig.2)
- Insert bar lower section (5) to the hole on
the machine housing (6) (see Fig.2c).
- Turn the lower bar section (5) clockwise to
the upside position. Install the other side the
bar. (see Fig. 2c)
- Slide the cable relief (2) on the connecting
bar (4).
- Mount the connection bar (4) to the lower
bar section (5) and fix it by means of the two
supplied screws and swing nuts. (Fig. 2b)
- Attach the handle bar (3) to the connection
bar (4) and fix it with the two supplied
screws and swing nuts. (Fig. 2a).
- Tighten all screws and nuts completely.
- Use the two supplied cable clips to hold the
cable in order.
4.4- Wheels
4.4.1- Wheels assembly (Fig.2)
- Slide the wheels (8) into the wheel axle on
the support (Fig.2d).
- Fix the wheels with washers (a) and screws
(b) using a hammer before putting them on
the hub (9).
- Attach the wheel support to the bar lower
section and machine housing,
- Fix with screw and nuts (Fig.2d)
4.4.2- Setting the wheels in transportation position or working depth position
The wheels of the unit can be set either on transportation position or on working depth position.
a) Transportation position: wheels are set on lowest position. (Fig. 3)
b) Working depth position: the rear skid is set on low position, while wheels are lift on upper position.
c) To set the position:
- turn the knob (11) clockwise on “UNLOCK” position,
- lift or lower the wheels
- turn knob back to “LOCK” position.