- Have defective switches replaced by an authorized service centre
- Do not use the tool if the switch does not turn it on and off.
11. Warning
The use of any accessory or attachment, other than one recommended in this instructions’ manual
may present a risk of injury (to persons or animals) and may cause damages.
The user and/or operator are solely responsible for any damages or injury caused to properties and/or
persons.
12. Have your tool repaired by a qualified person
This electric tool complies with the relevant safety rules.
Repairs should only be carried out by qualified persons using original spare parts; otherwise this may
result in considerable danger to the user.
The use of unauthorized parts or failure to follow the maintenance instructions may result in injury or
damage.
13. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above.
3.3- Safety warnings regarding the use
Important notice! Observe any national safety regulations regarding installation, operation and
maintenance.
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
4. Use only working accessories with a permissible speed at least as high as the no-load speed of the
machine.
5. Do not use tool if tool is damaged, eccentric or vibrating.
6. Do not use tool if the working accessories (blades, spikes) are damaged, cracked, eccentric or
vibrating.
7. Never seize or touch the working accessories (blades/spikes) during operation.
8. Work may create dust and projection of debris. Wear appropriate protective equipment (dust mask,
safety goggles…).
9. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
9.1. The following hazards may arise in connection with the tool’s construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Risk of injury if you touch the blade while in use
d- Exposure to electricity by using a defective cord or extension cord.
e. Risk of body injury or property damage from flying debris.
f. Health defects resulting from vibration emission if the power tool is being used over longer
period of time or not adequately managed and properly maintained.
9.2- The declared vibration total value has been measured in accordance with a standard test method
and may be used for comparing one tool with another, especially applicable when other tool as same
construction and is operated with same power supply.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning: The vibration emission during actual use of the power tool can differ from the declared
total value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
9.3. WARNING! This machine produces an electromagnetic field during operation.
