29
A
B
C
A
B
C
A
B
C
A
B
C
5
INSTALLATION OF SUPPORTS SUPPLIED WITH THE KIT
5.1 SUPPORTS WITH BRACKETS FOR WALL FITTING
Fig. 13
1. Secure the adjustable motor support (Ref.
A
) in the hole of the wall fitted bracket (Ref.
B
), as
shown in figure 13.
2. Secure the motor support on the plates C (Fig. 1 ref.
6
), using the bolts/nuts/M5 washers (Fig.
1 ref.
13
).
3. For adjusting the support height and for securing the plates, see chapter 6.
5.2 SUPPORT WITH SQUARE TO BE SCREWED
1. Secure the square support (Rif.
B
) to the wall, using the wall expansion plugs. (Fig. 1 ref.
13
)
2. Secure the adjustable motor support (Fig. 14 ref.
A
) in the hole of the square (Ref.
B
), as shown
in figure 14
3. Secure the motor support on the plates C (Fig. 1 ref.
6
), using the bolts/nuts/M5 washers (Fig.
1 ref.
13
)
4. For adjusting the support height and for securing the plates, see chapter 6
If the wall fitting bracket is not present, you may use the square to be screwed (Fig. 1 ref.
4
):
Fig. 14
6
INSTALLING THE ELECTRO-ROLLER IN THE BOX
After you have correctly installed the supports, as described in chapter 5, install the assembled electro-roller in the box:
1. Fit the motor head on the rapid fitting on the motor support (Fig. 16 ref.
A
). The motor must be oriented to enable access to the adjustment screws of the limit
switches (Fig. 16 ref.
B
).
2. Allow the telescopic components of the electro-roller to slide until the cap is inserted on the bearing in its support (Fig. 16 ref.
C
).
3. Check if the roller is positioned perfectly horizontally, if necessary modifying the heights of the supports (Fig. 16 ref.
A-C
), with the nut-locknut system.
4. Secure the plates of the motor support on the wall (Fig. 13-14 ref.
C
) using the expansion plugs (Fig. 1 ref.
13
).
5. Near the guide holes on the plates (Fig. 16 ref.
D
), drill a hole with a 5mm diam. bit suitable for iron.
6. In the holes (Fig. 16 ref.
D
), screw the supplied self-tapping screws (Fig. 1 ref.
13
), firmly securing the roller components to each other.
5.3 CAP SUPPORT
If it is necessary to install the cap support supplied with the kit (Fig. 1 ref.
11
), refer
to the instructions in paragraphs 5.1 and 5.2. The installation procedure is the
same as for the motor support, with only one exception: the plates are not used.
Fig. 15
Cap support
NOTE: The electro-roller can be installed with the motor sleeve part oriented to right or left.
G
B