RIB ACG9433, Руководство пользователя, Страница: 13 / 24

13
13
G
B
- A -
W
IRED KEYPAD PROGRAMMING
Card - B - is 2-channels, so it is possible to manage 2 systems or separate
commands. To program codes of the outputs:
CH1 = Digit the numeric code and confirm pressing A button.
CH2 = Digit the numeric code and confirm pressing B button.
- Remove cover - A - from receiver box cod. ACG9159.
- Do conections as on scheme.
- Power supply card - B - with 12V or 24V ac/dc
- Press and maintain pressed button - C -. You have 5 seconds to digit
the code (min. 4 / max 9 numbers) and confirm pressing button A or
with button B. You hear a “BEEP” to confirm the record of the new code.
- Release button - C - .
- Repeat these steps for every new code to record.
- Close receiver box cover - A -.
S
IGNALS
no “BEEP”s = code to record.
1 “BEEP” = code recorded.
2 “BEEP” = if code is already present in the memory.
3 “BEEP” = after deletion of one code.
4 “BEEP” = during deleting procedure. Code not present in
memory.
5 “BEEP” = memory full (max 125 codes).
10 “BEEP” = All codes deleted.
DELETING ONE CODE
Press and maintain pressed button - C - up to obtain a permanent “BEEP”.
Digit the code to delete (3 “BEEP” follows to confirm deletion).
Release button - C -.
DELETE ALL CODES
Press and maintain pressed button - C - up to when permanent BEEP
stops. (10 “BEEP”s follow to confirm total deletion).
Release button - C -.
Wired Keypad has backlighted buttons.
- B -
MAX
24V 1A
SIG
SIG
code ACG9159
ATTENTION:
CONNECT MAX 2 KEYPADS
IN THE CARD - B -
(to connect in parallel).
ATTENTION:
to do programming procedure
connect only 1 KEYPAD in the
card - B -.
TURN OFF POWER SUPPLY
BEFORE YOU CONNECT THE
CARD
C NA C NA
12/24 V ac/dc
CH1 CH2
WIRED KEYPAD - CONNECTIONS AND PROGRAMMING
channel A
- C -
channel B