RIB ACG9433, Руководство пользователя, Страница: 12 / 24

12
12
P
ROGRAMMING
Turn on power supply in order to proceed with codes programming.
a - Press programming button on RX 433-A radio receiver or on RIB CRX
control panel, to activate the learning procedure.
b - You have 10 seconds to digit the code (from 4 to 9 digits) and press
one of the 2 channels (A or B) (es. 1234A).
c - End the learning procedure pressing button on the radio receiver or,
wait 10 seconds so procedure ends by itself.
A
DD NEW CODES
The number of codes stored depends on the capacity of the receiver’s
memory.
- Repeat point “b” to add new codes.
- After 10 seconds without inserction of new codes the radio receiver
ends learning procedure by itself and the system becomes active.
NOTE: to use different radio signals from channels A and B, during
programming, you simply insert in front of the code to store the number
0, for example:
- To output a signal with channel C type 01234A
- To output a signal with channel D type 01234B.
For the quantity of codes to be stored refer to the receiver or control
panels RIB manuals.
RX433-A code ACG5055
single channel with connector for RIB control panels
RX433-A code ACG5051
double channel with connector for RIB control panels
RX433-A code ACG5056
2-channels with terminal block
RX433-A code ACG5052
2-channels with terminal block
RIB CRX control panels
with built-in radio receiver
PROGRAMMING RADIO KEYPAD WITH RECEIVERS RX 433-A
G
B