Page 4
9. Remove the (2) bolts at the top of the bagwell
area. Retain hardware.
Rear Seat Kit Installation
1. Loosely install the new front seat
back supports to the rear body
using the Original Hardware.
NOTE: Driver and passenger side
brackets are different.
2. Use a 3/8” drill bit to open up the (2) rear
and outer most holes in the bagwell area.
Drill completely through the rivet and the
frame. Driver side hole not shown.
3. Loosely fasten the vertical support brackets
to the bagwell area using (2) M10 x 50 Hex
Head Bolts, (4) Flat Washers and (2) Nylock
Nuts (Bag #1).
NOTE: Underbody may have to be trimmed if it
gets in the way of the hardware.
