RHINO Pro Series 301250, Руководство пользователя

Страница: 18 / 24

16
INSTALLATION INSTRUCTIONS
14. Tighten 5/16" Socket Head Cap
Screws into the recess in the bottom
handle assembly, one screw in each side
of the bottom handle.
15. See Step 14 above.
16. Slide the left side Handle Collar over
the threaded extended handle adapter and
hand tighten.
17. Thread the throttle cable extension
through the right side of the lower handle
assembly.
18. Run throttle cable extension along the
side of the body assembly.
19. Bring enough cable extenion through
the top handle assembly to attach the
throttle linkage to the engine.
20-24. Locate the throttle adjuster nuts and
spin the inner nut all the way to the rear of
the threads and spin the outer nut so that
there is still 3-5 threads showing. Install
the throttle cable end into the carburetors
throttle control linkage. Making sure that
the throttle linkage is contacting the set
screw. Spin both adjuster nuts towards the
throttle adjustment bracket till they are
snug. Check that the throttle control link-
age is still in contact with the set screw.
Using two 10mm wrenches hand tighten
the adjuster nuts. Activate the throttle,
making sure that the throttle linkage
contacts the stop when fully depressed.
Loosen nuts and readjust if needed.
*
Note: The top throttle has been pre-ad-
justed with factory settings, after installa-
tion the throttle may need to be adjusted
slightly for proper idle and operation.
25.
Place the ground screw through the
opening in the cable clamp along with the
eyelet wire on the wire harness, making
sure the eyelet wire makes contact with
the main body and is not inside of or on
top of the cable clamp. Use a ¼” socket
and reinstall the ground screw.
26.Locate the single wire harness (female
bullet connector) coming from the Honda
GX35 engine, connect it to the male bullet
connector on the wire harness used in the
previous step. Make sure that the connec-
tors snap together.
27. Using a wire tie supplied with the kit,
loop the first wire tie around both wire
harness wires as well as the throttle cable
coming from the upper throttle. With the
remaining two wire ties loop them around
the bullet connector and upper throttle
cable from the previous step, making sure
to secure the wire ties to both sides of the
bullet connector so that they are held in
place. Trim to length.
28.Replace the air filter cover.
29. Attach the lower handle assembly with
the two lower handle bolts.