RHINO Multi-Pro 301002, Руководство пользователя

Страница: 18 / 32

16
Multi-Pro
™
Service Instructions... continued
THE LARGE RADI-
US OF THE LARGE
RETAINER MUST BE POSITIONED
UPWARD FACING THE HAMMER
OR IT WILL CAUSE DAMAGE TO
THE DRIVER.
Clean and inspect the lower driver body
(p/n 301032) for any damage or exces-
sive wear. Replace if necessary. Lubricate
inside of the sleeve of the lower body with
Rhino
®
Pro Series Lubricant. Lubricate the
anvil with Rhino
®
Pro Series Lubricant.
Insert the anvil with new anvil o-ring into
lower body, making certain that the anvil
is seated into the lower body. Insert the an-
vil o-ring cup into the lower body. Discard
the used O-ring cup, O-ring (p/n 301618)
and Gasket. Replace with new O-ring cup
and Gasket. The O-ring is obsolete and no
longer needed. The assembly should look
like Fig. 12, but without the o-ring.
All threads on the bolts and in the body
and lower body need to be clean and free
of any dried threadlocker or debris. Apply
Loctite Primer N 7649 to the external and
internal threads. The primer must be dry
before assembly. Apply the gasket to the
lower body assembly by removing the
paper backing and exposing the adhesive
on one side. With the adhesive on one
side. With the facing the lower body, press
gasket into place making sure the bolt
holes are lined up. Apply threadlocker
to the threaded holes on the body. The
threadlocker needs to be applied starting
at the bottom of the threaded hole and
apply a bead of threadlocker up to the top
of the thread. With the gasket in place on
the lower body, remove the paper backing
on the other side of the gasket. Grasp the
Upper Handle Bracket and pull toward
the Upper Handle, depressing the upper
Springs. Seat the Lower Body onto the
upper Body making sure the bolt holes
are aligned. Gently let the upper handle
bracket slide back into place. Place the
lock washers onto the lower body bolts.
The lock washers are a two (2) piece de-
sign. Do not separate the parts of the lock
washer. Insert and start by hand the four
(4) lower body bolts through the lower
body and into the body. Use a 1/4" hex
wrench to tighten the bolts in a crossing
pattern. Check for any misalignment or
binding when joining the parts. Do not use
excessive force. Using a torque wrench
set to 132 lb/in (14.9 Nm) for stainless
bolts or 251 lb/in (28.4 Nm) for black
O-ring
O-ring
Anvil
O-ring
Cup
Anvil
with
O-ring
Large Retainer
Large Radius (up)
Fig. 16 -
Insert O-ring into Anvil O-ring
Cup, then insert Large Retainer (with large
radius up), then insert other O-ring.
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE