Press/Hold Auger lock pin. Rotate
Grinding Wheel counterclockwise.
Remove thumbscrews from
housing. Place on catch tray brkt.
Remove housing from
the auger assembly
Wipe the auger, rotary seal
and housing mounting plate
thoroughly using a dry cloth
Empty the hopper bin &
remove the shutter by pulling the
cotter rings and clevis pins
Wipe thoroughly internal and
external surfaces of the hopper,
shutter and pins using a dry cloth
Disassembly / Reassembly
Unscrew 3 captive screws, and seperate the
retaining ring from cover for cleaning. When
reinstalling these pieces, make sure the raised
weld nuts do not rest against the cover when
hand tightening the retaining ring and 3 thumb
screws. Failure to do so, may result in leaking.
Unscrew the two thumb screws which hold
the grinding plate on the auger housing
and remove for cleaning. Take notice of
the alignment notch which needs to be
located in the range as shown by the red
circle during the reinstallation process.
Alignment
Notch
CAUTION
: THE GRINDING PLATE MAY HAVE SHARP BURRS,
EDGES OR TEETH. PROCEED WITH CAUTION AND CARE.
Retaining ring
only installs
one way
Raised
weld
lip up
CAUTION
C
LE
AN
IN
G
/
S
AN
IT
IZ
IN
G
18
