S
PE
C
S A
N
D FE
A
T
U
R
E
S
A.
B.
C.
A.
B.
Reverse Detail of Hopper
Hopper
MOTOR INTERRUPTING SAFETY SWITCHES
The RHINO™ GRIND is equipped with 2 safety
switches to prevent injury during refill or cleaning.
1.) When the hopper or 2.) the front merchandiser
has been removed for cleaning, or is not properly
installed, the power
to the RHINO™
GRIND’s motor is
interrupted.
IT
DOES NOT
MEAN THAT
POWER TO THE
MACHINE IS ABSENT.
PLEASE PROCEED
WITH CAUTION!
A. Align the 4 tabs in the back of the hopper with the rear of
the RHINO™ GRIND. B. Tabs should rest in the slots
on the grinder body. C. Align front merchandiser ensuring
the tabs align with no gap. Assure front merchandiser
fully seats to chassis.
The RHINO™
GRIND should start
when the start/stop button
is pushed. If the button
is flashing red/yellow, check
for proper installation / alignment
at locations shown in A., B. and C.
and review Troubleshooting section.
WARNING
REMOVING THE HOPPER, OR FRONT MERCHANDISER
This shows how to remove and reinstall the hopper, or front merchandiser for
cleaning, maintenance, etc.
REMOVAL
The hopper simply
rotates up until you can
lift it straight up from
the RHINO
®
Grind chassis.
The merchandiser
may require a firm pull
to release from magnets.
HOPPER
MERCH.
HOPPER
MERCH.
REINSTALL
Align 4 tabs of
the hopper at the
rear, and rotate
it back into
position. The
merchandiser fits
into two slots and
rotates upward on chassis.
CHASSIS
CHASSIS
11
