RHINO 5047C, Руководство оператора

Страница: 51 / 80

OPERATION
OPERA
TION
Operation Section 4-15
© 2005 Alamo Group Inc.
7600A 06/05
Perform scheduled lubrication as specified in the
maintenance section.
Inspect the oil level and condition of oil reservoir
and replenish if needed. (Add specific type oil if
low)
Ensure there are no oil leaks and fittings are
properly connected.
DANGER! Do not operate this Equipment with hydraulic oil leaking. Oil is
expensive and its presence could present a hazard. Do not check for
leaks with your hand! Use a piece of heavy paper or cardboard. High-
pressure oil streams from breaks in the line could penetrate the skin
and cause tissue damage including gangrene. If oil does penetrate the
skin, have the injury treated immediately by a physician knowledgeable
and skilled in this procedure.
(SG-15)
DANGER! Never work under the Implement, the framework, or any lifted component
unless the Implement is securely supported or blocked up to prevent
sudden or inadvertent falling which could cause serious injury or even
death.
(SG-14)
Operation and Service
1. Before operating each season, grease the blower completely as per lubrication guide.
2. To prevent damage to the driveline, before operating the blower raise the three-point and check the PTO knuckle.
DO NOT exceed 30 degrees. Set the stop on the three-point lift to prevent accidental ovelift.
3. For best operation, travel at speeds that will let the blower efficiently handle the load. Speeds may vary with
depth and conditions of the snow. DO NOT move the blower at speeds that will push the snow. Avoid bulldozing
into snowbanks as this may possibly plug the spouts and put undue stress to all driveline components.
4. If the blower becomes overloaded in deep snow, raise the machine and remove the upper layer, move ahead, and
lower the blower for another pass.
5. After the first ten hours of operation, check and retighten all setscrews and bolts. Check the roller chain for
tightness and adjust the idler sprockets accordingly.
6. The oil bath housing for the drive assembly contains 5 gallons of standard SAE #5 wt. oil. The oil bath assures
long sprockets, chain life, and dissipates heat caused by moving parts. Periodically check the oil level and add if
necessary.
7. Each fan is protected by a shear bold located at the back of the fan shaft. Replace as required. Use only Rhino
shear bolts. CAUTION! Using a higher grade bolt my damage snowblower.
Oil
Reservoir