Rhin-O-Tuff HD6500, Инструкция

Страница: 19 / 28

Reception setup:
Loosen Paper Stop (shown in Figure T) then turn and move so that the Paper Stop Arm is aligned
with or above the center of page and width of page matches or exceeds the mark on the
horizontal guide, tighten Paper Stop. Loosen Drawer Screws (see Figure U) and pull out reception
drawer until sheet's top edge aligns with LINE “A” yellow label and bar edge (see graphics inside
drawer).
tighten screws. Lightly
Accessing the Die in the Punch.
Turn both power switches off before removing a die or performing maintenance. See Figure
V. To change the die on a punch, pull the forward APES System Reception mounting pin and pivot
the Reception away from the punch. This will allow access to the left die locking handle. Unlock
both handles, replace die, lock both handles, then swing the APES System Reception back in
place and replace forward mounting pin. The HD-6500 uses forward mounted die locking screws
and will not require this action.
17
Figure T Figure U
Figure V