Rheem Raypak CROSSWIND-30-I, Инструкция по установке и эксплуатации

Страница: 21 / 68

21
On/Off Models Only
The display controls general operation. The layout, main
functions and buttons are shown below.
MODE
TIMER INDICATOR
LIGHT A
TIMER
INDICATOR
LIGHT B
POWER ON/OFF
TIMER OFF
WATER TEMP
AND
TIME SETTING
CLOCK
Heat
Cool
TIMER ON
Figure 13. Operation Display, Models -40-O through -65-O
Symbol Designation Button Functions
Power Power Switch
Clock Set local time
Timer Off
Set the time required machine
auto-stop
Light A Shows the auto-stop time being set
Timer On
Set the time required machine
auto-work
Light B Shows the auto-work time being set
Cool
Shows the cool mode (for heat and
cool models only)
Heat Shows the heat mode
MODE
MODE Key
Heat or cool mode selection (only
available in heat and cool machine)
Down-
ARROW
Set required temperature and time
Up-
ARROW
Set required temperature and time
LED screen
Display time, temperature and
machine failure code
Table F. Display Button Functions
Using the On/Off Display Unit
Display defaults
• The LED screen will display the time when the
machine is off.
• The LED screen will display the current water
temperature in the pool when the machine is on.
To change from Fahrenheit to Celsius, press and HOLD
the Timer ON button for 10 seconds to change from
°F
to
°C
.
Heat/Cool Mode
1. Press the MODE button to switch from one mode to
another.
NOTE: Available only in heat and cool models.
Setting pool water temperature
Temperature can be adjusted either when the machine is
on or off.
1. Press UP
or DOWN to set your target pool
water temperature.
2. The numbers on the LED screen will flash during
adjustment.
3. After five seconds of inactivity, the LED will stop
flashing, the adjusted target temperature will be
saved, and the LED screen will revert to the default
display.
4. Later on, at any time, if you want to check the
temperature setting, press UP or DOWN
again to access its setting.
Setting the clock
1. The clock can be set either when the machine is on
or off.
2. Press CLOCK to set the time to your local time
zone. The displayed time on the LED screen will now
flash.
3. To set the hour press CLOCK again, then press
UP or DOWN .
4. To set the minute press CLOCK before it stops
flashing and then press UP or DOWN .
5. After setting, press CLOCK and the water
temperature will appears. After 30 seconds, it will
stop flashing and the LED screen will return to its
default.
Automatic on/off settings
The display can be programmed to turn the machine on
and off automatically.
Setting the ON time
1. Press CLOCK to access the timer function.
2. When the indicator light is on and the time is flashing,
press CLOCK again to set the hour. Use UP
or DOWN to adjust.
3. While the display is still flashing, press to set
minute. Use UP or DOWN to adjust.
4. After adjustment, press TIMER ON to confirm the
setting, and the water temperature will be displayed.
After 30 seconds, the controller display will be revert
to its default mode.