G R A M E R C Y S I N G L E M E T A L W A S H S T A N D
Q
M
L
6.
7.
8.
10.
13.
14.
9.
11.
12.
ASSEMBLY INSTRUCTIONS
CONT'D
:
Using a carpenter’s level, ensure that each leg is vertical. Mark the position of wall flange screw holes on the wall
with a pencil. And mark the position where anchor pins will rest in the floor.
Carefully place assembled washstand aside, and drill holes into the floor where marked(1/4” diameter x 7/16” deep).
Where marked, mount wall flanges to the wall with drywall anchors (K).
Replace metal foot pins in the feet of the assembled washstand.
Place washstand carefully in its final position with the side assembly rods placed in the mounted wall flanges and the
foot pins recessed into the floor.
One person should now hold the washstand in place while the other person tightens the Allen head set screws of the
two wall flanges (Do not over-tighten the set screws.)
Place one 3/16” rubber pad (I) on each of the four top surfaces on the washstand and using two people, lift the stone
top carefully placing it in position on top of the washstand base. If the stone top needs slight leveling, substitute 1/4”
pads (J) as necessary to stabilize.
Remove the stone top from the base and carefully place upside down on a flat nonabrasive work surface.
Using the setting tool (Q), hammer calk-in anchors (L) straight into pre-drilled holes on the underside of stone top.
(See illustration.)
5
OF 10