G R A M E R C Y S I N G L E M E T A L W A S H S T A N D
•
Professional two-man crew.
•
Water supply and drain piping installed according to local plumbing and building codes (sold sep
a
rately).
•
Wall and floor are square and plumb at installation site.
•
Vanity Base installed square and plumb with wall and floor. Vanity Base also needs to be level.
•
Ensure Stone Top is the correct size to match the Vanity Base.
•
Do not over-tighten parts during assembly
•
Make final adjustment of set screws after installation
•
The washstand may not be appropriate for locations with small children
•
The foot pins must be recessed into finished floor in order to reduct stress on the rods.
D
G
S
C
E
1. Place right side assembly (C) upside down and screw one of the legs (G) into the base of the round knuckle. Set right
side assembly aside on a flat, non-abrasive work surface.
2. Place left side assembly (D) upside down and repeat the process described in step 1.
3. With one person holding the right side assembly/leg and the other holding the left side assembly/leg. Carefully
position the center bar (E) in the collar opening of the round knuckle on each side. (See illustration.) Using Allen
wrench (H), adjust set screws (S) in collar openings on each side to secure the center bar. (
Do not over-tighten the
set screws at this point. Tighten them only enough to hold the rod in place. Set screws can be adjusted further after
the washstand is fully installed.
)
4. Remove the threaded foot pin (R) from the bottom of each washstand leg and place it to the side.
5. With one person on either side of the assembled washstand, carefully position the washstand upright in the position
where it will be mounted. Position wall flanges (F) on each side of the assembly, but leave them unattached.
PRIMARY INSTALLATION REQUIREMENTS:
WARNINGS:
ASSEMBLY INSTRUCTIONS:
4
OF 10