RGB Lights FlexiFlex, Руководство пользователя, Страница: 14 / 24

SERVICE & MAINTENANCE
Warning! Read “Safety Information” on page 2 before carrying out service or maintenance
work on FlexiFlex panels or any other component of the system. Lock out power to the entire
distribution system before servicing, cleaning or removing any cover. Refer any service
operation not described here to a qualified service technician.
Important! Excessive dust, smoke fluid and particle buildup degrades performance, causes
overheating and will damage equipment. Damaged caused by inadequate cleaning or
maintenance is not covered by the product warranty.
The extent of wear and tear depends heavily on operating conditions, maintenance and envi-
ronment, so it is impossible to specify precise lifetimes for optical components. However, you
will eventually need to replace the LEDs if their characteristics are affected by wear and tear
after an extended period of use and if you require panels to perform within very precise optical
and colour parameters.
CLEANING
Regular cleaning is essential for product life and performance. Buildup of dust, dirt, smoke
particles, fog fluid residues, etc. degrades the panel’s light output. Cleaning schedules vary
greatly depending on the operating environment. It is therefore impossible to specify precise
cleaning intervals. Environmental factors that may result in frequent cleaning include:
• Use of smoke or fog machines
• High airflow (HVAC, vents, etc.)
• Cigarette smoke
• Airborne dust (from building structures or the natural environment at outdoor events, for
example).
If one or more of these factors is present, inspect panels within their first 25 hours of operation
to see whether cleaning is necessary. Check again at frequent intervals. This procedure will
allow you to assess cleaning requirements in your particular situation. If in doubt consult a
qualified service technician about a suitable maintenance schedule.
Do not use abrasive, caustic or solvent-based products for cleaning, as they can damage plastic
or painted surfaces.
To clean panels:
1. Disconnect the panel from power
2. Blow away dust and loose particles with compressed air
3. Wipe the outside of the LEDs with a soft, lint-free cloth dampened with a solution of water
and detergent or auto shampoo. Apply gentle pressure only.
14