RGB Lights FlexiFlex, Руководство пользователя, Страница: 12 / 24

CONNECTING TO THE sPDS-480ca
WARNING: Ensure power is off before connecting lights. Disconnect power using the power
switch on the back of sPDS-480ca . Failure to do so could result in death or serious injury and will
void the warranty.
CONNECTING POWER TO SPDS-480CA
• Connect the IEC power cable to the back of sPDS-480ca . (See Fig. 6.)
• Make sure IEC Cable is fully seated in the receptacle, and that retainer clip is not hindering the
IEC from making a full connection.
CONNECTING FLExIFLEx TO SPDS-480CA
• Plug a fixture connector into a power output port on the back of sPDS- 480ca . Ports are labelled
1 through 8. (See Fig. 6.)
SETTING THE IP ADDRESS
1. Use the control buttons (up and down arrows) to scroll through and set the values for the IP
Address fields. Press the Select button to accept the value and jump to the next segment. Use
the Cancel button to return to the previous field.
2. After setting all values, press the Select button. The system prompts you to press the Select
button to confirm. The system indicates the IP address was saved.
NOTE:
If you do not confirm the IP address, it will not be saved.
NOTE: The first field (10) cannot be changed and the address should not be set to 10.1.3.100 or 10.1.3,101.
Figure 6. Rear panel of 24v sPDS-480ca
Figure 7. Front panel of sPDS-480ca
12