Front Side
Hold button with red and green LED
AC Adapter Jack
Input for AC adapter
Hold Button
Button used to denote the status (hold, monitor or alarm)
and to reset the alarm. Press and hold the Hold Button to
place the unit in a 30 second hold. The Hold Button
illuminates solid Green when the unit is in Hold mode.
Floor Sensor Jack
Sensor input (1/4 inch mono-phone jack)
Sensor Input Jack
Sensor input{RJlljack)
Nurse Call Jack
Input to connect to a nurse call system (1/4 inch mono
phone jack)
Alarm Speaker
Speaker for alarms and voice recordings
Inside Battery Box
,
'
Rec:on:llng
�
I .,.�
·� �·�
DllayTlmt
M T M
T
�S?s2 �
rii;::m'
I
I
I
I
•
[i::J
II] II] '
c:::ii::J @ @
C!!::J
�
1.5V AA Battery
�
�
1.5V AA Battery
�
�
1.5V AA Battery
�
<D
a,
J
Page 6 of 12
ST750 Control Unit
Inside Battery Box (continued)
Volume Switch
Alarm volume switch. (H , M , LIS )
•
H
= High volume
•
M
= Medium volume
•
LIS
= Low/Silent volume. When set at LIS and
connected to the nurse call station, the local alarm
is silent.
Delay Time Switch
Alarm time delay setting to avoid unnecessary alarm
caused by patient's tossing and turning. Delay setting
does not work with floor mats.
•
Os
I
ls/ 2s / 4s (s = seconds)
Melody/Tone Switches
Switch to set the alarm output type to enable either
Melody (M) or Tone (T) and then specify whether or not
voice is enabled. Settings are:
•
M
= Melody only
•
T
= Tone only
•
M
+
Voice
= Melody and Voice
•
T +Voice
=
Tone and Voice
Select Button
Press to select desired Melody or Tone. Choose between
8 melodies or 8 tones.
Nurse Call Output Switch
Allows you to specify the frequency of the alarm.
•
C
= Continuous-the alarm will be a constant
output until it is cleared.
•
P = Pulse-the alarm will pulse once every second
until it is cleared.
REC Button
Press the REC button to start voice recording (max. 10
seconds).
Recording LED
Lights up during voice recording.
ST750 Instruction Manual (0510-0496-
C
)
