Chair Mode (continued)
Toilet Sensor Pad
Place the toilet sensor pad underneath the toilet seat (as
per the instruction on the toilet pad) when seated.
ST710
Toilet sensor pad
Seat Belt Sensor
Position the patient so that the seatbelt connects
securely around their waist while sitting in a
wheelchair.
0
Seat belt
Test ST710 and chair / toilet / seat belt sensor
for proper operation before each use and
inspect for any signs of damage or excessive
wear. Please contact the distributor for
replacement if any damage is found.
Page 8 of 11
Floor Mode
0
Do not connect a bed or chair sensor and
floor mat sensor cable to the ST710 at the
same time. Operation of the bed/chair sensor
takes priority and the floor mat connection
will be disabled.
1.
Place the floor sensor mat where you desire to detect
patient's movement.
2.
At the entrance
-
'
I/
Alert when patient tries
to leave the room
By
the bedside
Alert when patient
tries to leave the bed
Plug the floor mat sensor cable into the ST710 sensor
jack. Doing so automatically places the ST7 l 0 in Floor
Mode. Removing the floor mat sensor cable from the
ST7 l 0 turns off Floor Mode operation and returns the
ST7 l Oto Bed Mode/Chair Mode. Make sure the cable
will not interfere with the bed wheels or movable bed
components and that no one will step on them or
stumble over them.
3.
While in Floor Mode, the ST710 alarms immediately
when pressure is applied to the floor mat sensor. The
Delay Time defaults to O seconds when the ST710 is in
Floor Mode.
4.
The alarm time delay for floor mode is always zero (0)
seconds regardless of the position of the delay switch.
5.
Check if the ST710 and the floor sensor mat are working
properly. (See page 10,
Testing the System
for detail.)
0
Test the S T710 and floor mat sensor for
proper operation before each use and inspect
for any signs of damage or excessive wear.
Please contact the distributor for replacement
if any damage is found.
Floor sensor
ST710 Instruction Manual (0510-0519-
B
)
