Usin the ST710 S stem
Bed Mode
Chair Mode
1.
2.
3.
4.
5.
6.
Place the bed sensor pad just below the patient's back,
underneath the sheets, overlays or incontinent pads. If
early detection is necessary, place the sensor pad
below the patient's shoulder.
Plug the sensor cable into the ST710 sensor jack.
Make sure the cable will not interfere with the bed
wheels or movable bed components and that no one
will step on them or stumble over them.
Set the alarm volume by sliding the volume switch.
Set the alarm time delay by sliding the delay time
1.
2.
3.
Plug the sensor cable into the ST710 sensor jack.
Make sure the cable will not interfere with the
chair wheels or movable chair components and
that no one will step on them or stumble over
them.
Set the alarm volume by sliding the volume
switch.
switch to set how quick
l
y an alarm should go off when
4.
receiving the si
gn
al from a sensor.
Set the alarm time delay by sliding the time switch
to set how quickly an alarm should go off when
receiving the signal from a sensor.
Check if the ST710 and sensor is working
properly. (See page 10,
Testing the System
for
detail.)
Check if the S T710 and the sensor pad are working
properly. (See page 10,
Testing the System
for detail.)
Position the patient on the bed so that the patient is
lying on the sensor pad. The Green LED starts
blinking to indicate the patient is now being
monitored.
Chair Sensor Pad
Place the chair sensor pad on the wheelchair seat so
that the pad will be underneath the patient when
seated.
0
Test the ST710 and the bed sensor pad for
proper operation before each use and inspect for
any si
gn
s of damage or excessive wear. Please
contact the distributor for replacement if any
damage is found.
ST710
Chair sensor pad
ST710
ST71 0 Instruction Manual (0510-0519-
B
)
Page 7 of 11
