Page 8
The installation of the appliance must meet all the relevant European, national, and local criteria.
Prior to installation the following points should be considered;
•
The position of the heater for the optimum efficient distribution and circulation of warm air.
•
The position of the heater relative to the route of the flue
• The position of the heater relative to the supply of fuel
• The position of the heater relative to the electrical services, and if appropriate, any additional controls.
• The position of the heater relative to the supply of fresh air
•
The height if applicable at which the heater is to be mounted and potential stratification /circulation problems.
• The position of the heater relative to service and maintenance requirements
CAUTION
The heater must not be installed within an area where the conditions are unsuitable, e.g. where the atmosphere
is highly corrosive, has a high degree of salinity, or where high wind velocities may affect burner operation.
Suitable protection should be provided for the appliance when it is located in a position where it may be
susceptible to external mechanical damage from; for example, fork lift trucks, overhead cranes etc.
1.5 Delivery and pre-installation checks.
The heater is supplied wrapped in heavy duty protective polythene. On receipt of the heater, the following checks
should be carried out;
• The model is as per order.
• That it is undamaged.
• That is suitable for the fuel supply.
• That is suitable for the electrical supply
If any of these points are not satisfied then contact should be made with the suppliers sales office as soon as possible
by telephoning the number shown on the rear page. In the case of claims for damage, this must be signed for as
damaged and reported in writing within 24 hours of delivery, in order to comply with insurance criteria.
1.6 Warranty
The heater is supplied with a 1 year parts and labour warranty and a further year on all parts excluding consumables.
In addition to this there is a 10 year time related warranty on the combustion chamber.
The warranty commences from the date of dispatch from the manufacturer, and is subject to the terms detailed within
the Manufactures ‘conditions of business’.
Note (i)
- The warranty may be invalidated if -
• The installation is not in accordance with the general requirements of this manual.
•
The flue arrangement and air supply for the heater are not in accordance with the manufacturers recommendations, codes of practice, or
similar standards.
•
Air flow through the heater is not in accordance with the manufacturers technical specifications.
• Internal wiring on the heater has been tampered with or unauthorised service or repairs undertaken.
• The main electrical supply input to the heater has been interrupted during the heating mode.
• The heater has been subject to and affected by the ingress of water in any form.
•
The heater is not operated at the rating(s) laid down in the manufacturers technical specifications.
• The heater has not been operated or used within the normal scope of its intended application.
• The manufacturer’s recommended minimum service requirements have not been complied with
Содержание OUH 100
Страница 46: ...Page 46 Notes...
