Rexroth Indramat DURADRIVE SYSTEM200, Руководство по планированию проекта

Страница: 77 / 86

RECO PLC ISP200-R/G2 List of Figures
16-1
DOK-CONTRL-MTS-R0*.2G2-PR01-EN-P
16 List of Figures
Fig. 1-1: MTS-R01.2 and MTS-R02.2 1-1
Fig. 3-1: Hazard classification (according to ANSI Z535) 3-1
Fig. 4-1: Dimensional drawing of MTS-R01.2 and MTS-R02.2 4-3
Fig. 4-2: RMB02.2-02 module carrier 4-4
Fig. 4-3: Connection of one RMB02.2-02 and several RMB02.2-04
module carriers 4-4
Fig. 4-4: RMB02.2-04 module carrier 4-5
Fig. 4-5: Connection of several RMB02.2-04 module carriers 4-5
Fig. 5-1: DIP switch for parameterization of the PROG interface 5-1
Fig. 5-2: Setting of the PROG interface for the MTS-R01.2 and the MTS-
R02.2 5-1
Fig. 5-3: BT bus overview 5-2
Fig. 5-4: Storage requirements of operating devices 5-3
Fig. 5-5: Storage assignment of BT bus 5-3
Fig. 6-1: Setting of slot addressing 6-1
Fig. 6-2: Maximum number of RMB02.2-04 carriers fitted 6-2
Fig. 6-3: Maximum number of RMB02.2-02 and RMB02.2-04 carriers
fitted 6-3
Fig. 6-4: Fitting variants for RMB02.2-02 6-3
Fig. 6-5: System grounding in connection with the ISP200-R 6-4
Fig. 6-6: Connection of the supply connector X1 6-5
Fig. 6-7: RecoBus I/O modules in the memory of the PLC 6-6
Fig. 6-8: Division of diagnosis double word / status information 6-7
Fig. 6-9: Explanation of status bit 31 6-7
Fig. 6-10: Error detection 6-8
Fig. 6-11: Explanation of the diagnosis bit 6-8
Fig. 6-12: Voltage monitoring 6-9
Fig. 6-13: Bit explanation 6-9
Fig. 6-14: Example of an external power failure 6-9
Fig. 6-15: Operating states of the ISP200-R 6-10
Fig. 6-16: Error codes of the ISP200-R 6-10
Fig. 6-17: Pin assignment of the PROG interface X10 and the COM
interface X16 6-11
Fig. 6-18: Pin assignment of the BT bus X15 6-11
Fig. 7-1: MTS-R01.2 7-1
Fig. 7-2: MTS-R01.2 with INTERBUS connection 7-2
Fig. 7-3: MTS-R01.2 type code 7-3
Fig. 8-1: MTS-R02.2 8-1
Fig. 8-2: MTS-R02.2 with INTERBUS connection and 4 serial interfaces
8-2
Fig. 8-3: MTS-R02.2 type code 8-3
Fig. 9-1: P.C.B. LK IBM 2 9-1
Fig. 9-2: Setting of DIP switch S1 9-2