REXON AP3300, Инструкция по эксплуатации

Страница: 8 / 20

5
Installation
Know Your Thicknesser (Fig. 1)
1. Cap
2. Tool Storage
3. Depth Adjustment Handle
4. Depth Scale Pointer
5. Depth Scale
6. Front Extension Table
7. Depth Lock Lever
8. No Volt Release (NVR) Switch
9. Power Cord Brackets
10. Power Cord
11. Rear Extension Table
12. Main Table
13. Carrying Handle
14. Dust Collector
Specifications
Motor........................1800 W, 220 V~ 60 Hz
Number of Blade........................................2
Blade Highest Speed................. 9,250 min
-1
Maximum capacity
Max Cutting Length.........................330 mm
Max Depth of Width.........................127 mm
Max Depth of Cut........................0 - 2.4 mm
Feed Speed................................. 7.3 m/min
Thickness of Cut...............3.2 mm - 150 mm
NOTE: Move all parts to
the desired work site before
assembling them together. Follow
the assembly instruction and
carefully assemble the tool with the help of
a second person.
WARNING! For your own safety, never
connect the plug to power source outlet
until all assembly steps are completed
and you have read and understood the
safety and operational instructions.
Assembly
INSTALLING THE DEPTH ADJUSTMENT
HANDLE (FIG. 2)
1. Place the depth adjustment handle (1)
on the right hand side, on the top of the
machine.
2. Insert the hex socket bolt (2) into the
handle (1). Tighten the hex socket
bolt (2).
3. Press the cap (3) on the left hand side.
NOTE: The depth adjustment handle can be
installed on either the right-hand side or left-
hand side. The illustration shows the depth
adjustment handle on the right-hand side.
INSTALLING POWER CORD BRACKETS
(FIG. 3)
Power cord brackets (1) are provided for
convenient power cord storage.
1. Attach the power cord brackets (1) to
the back of the thicknesser, as shown,
with two screws (2).
2. Tighten the screws (2).
INSTALLING THE DUST COLLECTOR
(FIG. 4)
1. Attach the dust collector (2) to the back
of the thicknesser, as shown, with three
screws (1).
2. Thread the three screws (1) to the
pre-drilled holes (3) in back of the
thicknesser.
3. Tighten the screws (1).
NOTE: This tool was accurately adjusted
before shipping from the factory. Check
the following accuracy and readjust them if
necessary in order to obtain the best results
in operation.
Setting the Tool
WARNING! For your own safety, never
connect the plug to power source outlet
until all assembly steps are completed
and you have read and understood the
safety and operational instructions.