Deskside and Office 230v
45
26/05/99
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
5.
Holding the sub-assembly together, locate the ‘motor end’ side plate on to the stripper
plate/safety flap tabs and ends of the cuttings shafts. Tap gently into position. Before closing
completely, fit the bin full flap, blade angles towards the rear.
6.
Refit rear tie bars and tighten bolts with lock-washers under heads.
7.
Check operation of safety flap on its cams.
8.
Refit all pop rivets.
9.
Refit motor along with the top tie bar.
10.
Replace gears and gearbox cover.
11.
Fit cutting head into cabinet, reconnect all wires.
12.
Replace top cover.
13.
Test operation.
MODELS 250 S5 (1250 S5 VERY SIMILAR)
Removal
1.
Remove top cover, cutting head and sensors as described in sections 1,2, and 4.
Replacement of damaged cutter blades and/or strippers – disassembly:-
1.
Stand the head assembly upright, on the ‘gearbox end’.
2.
Cut away pop rivets from ‘bearing end’.
3.
Undo bolts holding one tie bar and two stripper support bars in place.
4.
Remove ‘bearing end’ side plate, together with bearings, bearing retaining plate and bin full
flap.
5.
With ends of cutter shafts exposed, loosen and remove the lock nuts.
6.
Take off the ‘top hat’ collar.
7.
Remove cutters, spacer rings and stripper plates to reach the damaged section. Note the order
in which the various parts fit together on the cutter shafts.