Deskside and Office 230v
40
26/05/99
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
SECTION 7 – TIE BARS (STRIPPER SUPPORT BARS), CUTTING
SHAFTS, STRIPPER PLATES, (FEED CHUTES) PAPER GUIDES.
MODELS 250 S2
Removal
1.
Remove top cover, cutting head, auto start sensors, motor and gears as sections 1, 2, 4, 5 & 6.
2.
Remove three gear locating pins by gently tapping with a hammer on their extended ends.
3.
Drill out or chisel away four pop rivets holding side assemblies to stripper plates.
4.
Undo bolts and remove the two tie bars.
5.
Slide side assemblies off their tabs on the stripper plates and off the cutting shafts. If
necessary, tap gently with a soft hammer.
6.
Separate cutting shafts from their slots in the stripper plates.
7.
To separate stripper plates, untwist tabs on the two paper guides and pull plates apart.
Replacement
1.
If removed, refit new paper guides, twisting the tabs to fix the stripper plates.
2.
Hold the two cutter shafts into position in the slots of the stripper plate, so that their ‘bearing
end’ extensions are equal (NB shaft with the longer ‘motor end’ extension is the rear shaft,
nearest the motor).
3.
Slide ‘bearing end’ sideframe assembly over the cutting shafts and onto the stripper plate
tabs.
4.
Holding the sub-assembly together, locate the ‘motor end’ sideframe assembly onto the
stripper plate tabs/cutting shaft extensions. Tap gently into position.
5.
Refit two tie bars and tighten bolts with lock-washers under heads.
6.
Refit four pop rivets.
7.
Refit auto start sensors.
8.
Replace three gear pins; smooth end first, so that the grooved ends are flush with the shaft to
enable the gear to slide freely into place.