Deskside and Office 230v
35
26/05/99
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
SECTION 4 – AUTO START SENSORS (ALL MODELS)
Removal
1.
Remove top cover as for VISUAL INSPECTION
only, (models 1250) See Section 1.
2.
Unplug (MODELS 250 and 1150) the auto start
connector from the PCB.
3.
Find the two sensors in their positions on the top and
bottom stripper plates (straight cut models) or in-feed
chutes (cross cut models).
4.
Using a suitable tool (tube spanner), sufficiently loosen the small nut fixing the sensor so that
it may be moved out of its location in the stripper place and away from the M3 stud. Repeat
for the other sensor. Note: for 1150 S3, 1250 S3 & 1250 S5, the infeed chutes must be
removed from the cutting head to gain access to the sensors.
5.
Cut away cable ties as required, and remove sensors from the machine.
Replacement
1.
Fit sensor assemblies into their correct locations on the stripper plates/in-feed chutes, and
under the flat and lock washers. Tighten nuts.
2.
Re-route wires and replace cable ties.
3.
Refit all push-fit connectors.
4.
Replace top cover (section 1).
5.
Test operation.
View of One Half of the Paper Feed Sensor
