Revv Owner’s Manual - 7
set up & power up
It is very important to place the amplifier in a dry location that provides
4-6” of space between the rear of the amplifier and anything in the area
that has been designated for the amplifier. Tubes produce heat, and any-
thing flammable should be kept away. Verify that the heat vent is free from
obstruction so that the heat produced by the tubes can escape from the
interior of the amplifier.
Make sure that the power and standby switches are in the off (down)
positions. Connect the amplifier to a speaker cabinet using a good quality
speaker cable while making sure to use the correct speaker jack to sup-
port the speaker cabinet impedance. (If using the internal load, make sure
the load button on the rear is set accordingly) Next, connect the AC
power cord to the amplifier mains connector on the rear of the amplifier
and then to an AC outlet.
At this point, all other peripherals can be connected to the amplifier as
well including:
•
FX Loop
•
Guitar and Shielded Cable
•
MIDI
•
XLR
•
USB
•
Revv Cabinet Lighting
•
Headphones
Note: A high-quality shielded instrument cable is recommended for guitar
input as well as FX loop connections to prevent unwanted noise.
1.1