5
EN
7.4V 360mAh
Li-Ion ba
ttery
1. Rotate the latches at the rear of the boat to release the canopy.
2. Remove the canopy from the hull by pulling forward and then up and away.
1. With the canopy removed, place the battery on the horizontal
platform and secure it with hook and loop tape.
2. Connect the battery pack to the ESC power connector.
Canopy Removal
Installing the Battery
1
1
2
2
Discharging a Li-Ion battery below 3V per cell may damage your
battery. The included ESC protects the boat battery from over-
discharge using Low Voltage Cutoff (LVC). Before the battery charge
decreases too much, LVC removes power supplied to the motor. Power
to the motor pulses, showing that some battery power is reserved for
boat control and safe landing.
Disconnect and remove the Li-Ion battery from the boat after use to
prevent trickle discharge. Charge your Li-Ion battery to about half
capacity before storage. During storage, make sure the battery charge
does not fall below 3V per cell. LVC does not prevent the battery from
over-discharge during storage.
NOTICE:
Repeated operation to LVC will damage the battery.
Low Voltage Cutoff (LVC)
