13
13
13
13
Using the Revolabs Solo™ XLR Microphone Adapter
1. Remove the XLR Microphone Adapter from the Charger Base.
The adapter turns on and mutes automatically when removed
from Charger Base (flashing RED LED).
2. The XLR Microphone Adapter is attached to a standard dynamic
microphone (such as a Shure SM58) to convert it from a wired
microphone to a wireless microphone. The Adapter does not
provide phantom power or bias current so it cannot be used
with condenser microphones.
3. With the microphone attached, un-mute the XLR Adapter by
pressing and releasing the
MUTE
button (confirm by viewing
flashing GREEN LED). Note: if the microphone has an on-board
mute switch, this switch must also be un-muted prior to use.
4. To turn the XLR Adapter off, return the microphone unit to the
Charger Base or press and hold the
MUTE
button for ~10
seconds until the LED turns solid RED and release button.
Always remove the microphone from the XLR Adapter by pressing the latch switch and
separating the parts before returning the XLR Adapter to the Charger Base.
5. If the XLR Adapter is moved too far from the Base Station (~100 feet (30 meters)) the connection
will be dropped (LED flashes all colors) and the audio will mute. After 15 seconds the microphone
will beep 5 times, and will continue beeping every 30 seconds to indicate that it is out of range.
Move the XLR Adapter closer to the Base Station and the connection will automatically be re-
established to its original state, and the beeping will cease. If not, the XLR Adapter will continue
beeping until it turns off in about 15 minutes.
Adjusting the Volume
The volume of the microphone is set at the factory and cannot be adjusted on the wireless
microphone. Access to each channel is provided on the Base Station for external amplification.
Note:
Moving the wireless microphone closer to the mouth will
increase the volume.
To change the volume on the earpiece, use the dial on the earpiece
wire. Turning the dial towards the earpiece will increase the volume,
and turning the dial towards the microphone will decrease the volume.
Use the attached clothing clip to secure the earpiece wire.
