9
9
9
9
Using Multiple Systems
If more than one Revolabs Solo™ Executive Base Station is required for an area, each unit needs to
be interconnected with a sync cable using the supplied mini-phoenix connector. The three terminals
correspond to positive
+
, negative
−
−
−
−
, and ground
(seen left to right with the connector installed).
Use the screws on top of the connector to first loosen the terminal to insert an appropriate three
conductor cable (3 conductors, or 2 conductors and shield), and then tighten the screw to secure.
Push the connector onto the pins labeled
BUS
. Each additional system should be connected by
paralleling the conductors through the phoenix terminals. For example, there would be two
conductors in each of the three terminals of the second Base Station in a three Base Station system
One Station needs to be set as the
REMOTE
unit by sliding the switch next to the
BUS
port to the right.
The other units should remain in the
LOCAL
setting to the left (default position). The
LOCAL
unit
manages the entire system and distributes microphone transmission across the available channels
to maintain frequency integrity, and also coordinates system muting.
Note:
The switch must be in the
LOCAL
position for a single Base Station system. Microphones will
not function if the switch is in the
REMOTE
position. The Power Switch must be recycled (off/on) for
the status change to take effect.
The maximum number of systems for a given area in North America is two 01-EXESYS and that
may include one 01-EXESYS4 (16 channels maximum).
The maximum number of systems for a given area for EU is three 03-EXESYSEU that may include
two 03-EXESYSEU4 (24 channels maximum).
Revolabs Solo™ Executive Microphones
Note: Microphones in new systems must be paired to the Base Station with
each microphone assigned to a unique channel on the base unit. See pairing
instructions below.
The Revolabs Solo™ Wearable Microphones are synchronized to the Base Station and can be worn
on the user’s shirt pocket, lapel or on a lanyard. They provide high quality full duplex audio between
each user and the conferencing or audio system.
1. Mute Button — press to mute, un-mute and pair microphone.
2. LED display — visual status for mute, un-mute, and pairing.
3. Pocket clip — attaches microphone to user.
4. Earpiece jack — accepts the 2.5mm plug for the earpiece.
5. Charging port — docks to all Solo battery charger units.
1
5
4
2
3
