16
System Functions
The following table shows the functions supported by the solo
Desktop System:
Function
Charger
Base
LED
Status
Wireless
Microphone
LED Status
Action
Enter Pairing Mode
Off
Off
Press the Microphone
MUTE
button for
about 7 seconds (LED solid RED), and
then press the
MUTE
button on the
Charger Base for about 7 seconds
(LED solid RED).
Mute / Un-mute
On
On
A short press of the Microphone
MUTE
button or Charger Base
MUTE
button
causes flashing RED LED on each unit
indicating that the Microphone has
audio muted. Pressing either
MUTE
button again will un-mute Microphone
(flashing GREEN LED on each unit).
Turn Off Microphone
On
On
Press and hold the Microphone
MUTE
button for about 10 seconds, until the
LED stays solid RED, and then
release.
Or
Dock the Microphone into the Charge
Base for less than 2 seconds.
Turn On Microphone
Off
Off
Press and hold the Microphone
MUTE
button for about 3 seconds, until the
LED shows solid GREEN.
Or
Dock the Microphone into the Charge
Base for at least 4 seconds.
1
Safety and General Information
IMPORTANT INFORMATION ON SAFE AND EFFICIENT
OPERATION. READ THIS INFORMATION BEFORE USING
YOUR DEVICE.
FCC User Information
FCC Registration Number: 0014898290
FCC ID Number: T5V02DSKSYS
solo Desktop Charger
FCC ID Number: T5V01EXEMIC
solo Desktop Microphone
FCC Notice to Users
Users are not permitted to make changes or modify the
equipment in any way. Changes or modifications not
expressly approved by Revolabs, Inc. could void the user’s
authority to operate the equipment
.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE: Federal Communications Commission
(FCC) Radiation Exposure Statement – This equipment
complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
