1200-000002 r04 2 UPDATED 10/25/2022
Product Contents
3.
4.
CAUTION
: DO NOT cut through the protective
storage box to avoid any damage to the device.
1.
Carefully cut the tape covering the shipping box to not
damage the storage box inside.
2.
Remove the storage box from the shipping box.
•
Cut the tape dots located on the sides of the
storage box.
3.
Open the one seal on the storage box to reveal the Cap
and support base.
4.
Lift the support base to reveal the accessory kit.
5.
Remove the accessory kit and carefully read the Quick
Start Guide on the box lid or in the app manual.
6.
Remove the accessories contained inside the accessory
kit:
•
USB-to-Magnetic Micro-USB cable
•
Travel Bag
•
AC Adaptor
•
Adjustment Headliners
7.
Charge the Cap for at least one hour prior to use with
the AC adaptor and magnetic micro-USB cable.
5.
Adjusting the Cap
The Cap comes with front standard and back 10mm headliners
installed as illustrated below. The Cap should not be loose
enough that it falls off the head with ease, nor should it fit too
tightly. A proper fitting Cap is an important step for a reliable
treatment.
NOTE: Light emitting area (emission aperture) shown above. Applied Part.
To Adjust Headliners:
1.
A sensor detects when the Cap is on the head and
close to your forehead. If the Cap needs adjustment,
remove the 10mm back headliner from the headliner
dots. If loose, replace with the optional 20 or 30mm
back headliner. If tight, replace with the optional
standard back headliner.
2.
Fit test: press the Cap against your forehead. If a
pinky finger can still fit between the Cap and the
back of your head, then the Cap is too loose.
NOTE: To ensure proper sensor connection, the thick headliners
should only be used in the back of the Cap. The front headliner is
only to be replaced for sanitary purposes. For consistent fit and
wear, it is suggested to replace headliners every three months.
Replacement headliners can be ordered at REVIAN.com.
