Retsch TG200, Руководство по эксплуатации

Страница: 13 / 28

2/25/2013

Retsch GmbH
13
0002
Operating the TG200
Switching on / off
E
The main switch E is located on the right hand side of the rear panel
of the TG200

Switch on the main switch

ON lights up in the display drying mode

000 lights up in the display temp °C/°F

10 lights up in the display air flow

LED interval off lights up

Two dashes (
- -
) light up in the display time

The values appear at the first start. If the values are
changed they are retained at the end of the programme
and appear when switching on again and pressing the
START key.
The TG200 is now ready for operation, without interval, for
continuous operation without heating and with minimum fan power.
Starting – interruption - stopping
16a
15 16
Starting:
Press START / key 15
 Green LED over key 15 lights up
 TG200 starts with specified values.
 Red LED over key 16a flashes as long as a temperature has not
been specified.
 Specify temperature, red LED is extinguished, green LED lights
up.
During the drying period the temperature is kept constant within a
tolerance. This means that the heater is switched off when the
specified temperature has been reached and is switched on again
when the temperature drops below the specified value. A
temperature difference of +/- 2°C or +/-50°F is possible here.
Quick start with full power:
Press START / key 15 twice
 Green LED over key 15 lights up
 TG200 starts with full heating power and fan power for an
indefinite running period
 The measured temperature is displayed
Stopping:
 Press STOP / key 16 – heater is switched off
 Red LED over key 16 flashes
 Press STOP / key 16 a second time – everything is switched off
 Red LED over key 16 lights up
 The complete display except on is extinguished
 Activate LED displays = press key 15 once
 New values can be entered
 Press START / key 15 a second time

Function is carried out as with Starting