Retsch AS200 tap, Руководство пользователя

Страница: 25 / 48

First Commissioning
25

Turn the locking bolt ( F ) by approx. 90° to release the pin, and let go of the locking bolt. The
pin of the locking bolt now secures the tapping arm.
To make it easier to loosen the clamping screws, the position of the clamping levers (
B ) can be
adjusted independently of the clamping screws.

Pull the clamping levers ( B ) forward until they disengage audibly. The clamping levers can
now be moved independently of the clamping screws.

Turn the clamping levers ( B ) to the desired position.

Press the clamping levers ( B ) backwards again until they engage audibly. The clamping
levers are now again connected to the clamping screws.
Fig. 8: Position the clamping lever (left), adjust the height of the sieve plate (right)

Loosen both clamping screws and slide the sieve plate ( C ) downwards.

Tighten both clamping screws again.

Place the desired sieve stack including the sample material and sieve lid ( D ) centrally on the
sieve plate ( C ).

Then again, loosen both clamping screws and slide up the sieve plate ( C ) together with the
sieve stack until the upper edge of the sieve lid forms a plane with the guide ring ( FR ).

Tighten both clamping screws again.

Release the tapping arm ( A ) again by pulling the locking bolt ( F ) forward again and rotating it
by approx. 90°. The pin is now held inside the locking bolt and no longer engages with the
tapping arm.
Fig. 9: Insert the sieve stack
C
B
F
D
FR
A