Retsch AS 400 control, Руководство пользователя

Страница: 37 / 50

Error Messages and Information Notes
37
9 Error Messages and Information Notes
9.1 Error Messages
Error messages inform the user about detected device or programme errors. In the event of an
error message, a fault has occurred, in which the operation of the device or the programme is
automatically interrupted. Such faults must be resolved before next startup.
Error code Description Measures
E00 No errors in memory

The test of the memory has been completed
without error.
E10 Drive overload

Switch off the main switch and wait for 30 s
before switching on again.

If the error persists, contact service.
E26 Failure frequency
converter

Switch off the main switch and wait for 30 s
before switching on again.

If the error persists, contact service.
E45 Failure acceleration
sensor

Switch off the main switch and wait for 30 s
before switching on again.

If the error persists, contact service.
9.2 Information Notes
Notices inform the user on specific device or programme processes. The operation of the
device or programme may be interrupted briefly, but there is no fault. The information notice
must be acknowledged by the user to continue the process. Information notices provide
additional information for the user as an aid, but do not represent any device or programme
errors.
Notice code
Description Measures
bS Display of the complete
runtime in hhh

Press the button to exit the display.
CAL Calibration required

Press the button to exit the display.

Contact the service to arrange an
appointment for the calibration.
dA Current date required The device was not connected to the mains or
off for more than 30 days, whereby the battery
is discharged and the current date has been
deleted.

Press the button. The time display
shows the month "01". The amplitude
display shows the year "-00".

Use the respective "+" and "-" buttons to set
the current month (e.g. "04" for April) and
the current year (e.g. "-16" for 2016).

Press the button to save the current
date and to exit the display.

Leave the device connected to the mains
and powered on for at least two hours, in
order to fully charge the battery.