1
-
2
-
REFLECTORS
Attach the plastic brackets to the handlebar and seat post. (Figure 14 & 15).
Slide the reflectors onto the brackets (white in the front, red in the back)
•
•
•
•
•
•
•
TIRES
Locate the tire manufacturer’s recommended inflation pressure found on the tire sidewall (listed as
“PSI”).
Using a hand or floor pump with a gauge, begin to inflate the tire to half its recommended inflation
pressure and check to see that the tire is properly seated on the rim. Be sure to inspect both sides
of the tire for proper fit.
If the tire is seated unevenly or bulges out along the rim, let some air out of the tire and reposition
the tire by hand so that it sits evenly on the rim.
Continue to inflate the tire to the manufacturer’s recommended pressure.
Do not exceed the recommended pressure as this will cause an unsafe condition potentially
causing the tire to unexpectedly explode.
Do not use a compressed air device to inflate your tires as the rapid inflation of the tire can cause it
to explode.
Tires and tubes are not warranted against damage caused by over-inflation or punctures
from road hazards.
.
BEFORE YOUR FIRST RIDE
:
We strongly recommend you take your bike to a professional bike shop
and have them check your work and fine tune the bike to ensure your bike is safe to ride.
SERIAL NUMBER
:
It is important that you locate and record the serial number of your bicycle in case of a recall or if the
bicycle is stolen. The serial number can be found under the crank bottom bracket stamped into the
frame.
15
14
