Retigo vision, Техническая документация инструкция, Страница: 14 / 16

MAINTENANCE AND CLEANING
1 2
M A I N T E N A N C E A N D C L E A N I N G
Maintenance and cleaning must be perfor-
med by qualified personnel only. Maintenan -
ce and cleaning of the heat exchanger
should be done when decrease of perfor-
mance occurs, but at least once a year. The
grease filters can be cleaned in a dishwa-
shing machine.
Disconnect the hood from power supply and let it cool
down before you start cleaning.
The cleaning steps:
- Remove the hood from the combi steamer (see picture
V.) a place it on a suitable working table.
- Remove the grease filters.
- There are 12 M5 screws on the front side of the steam
trap. Unscrew these screws with a screw driver and
remove the steam trap from the hood – position 1.
- Unscrew the safety plate and the dividing partition –
position 2.
- Disconnect the motor power cable connector – pos. 3.
- Remove the heat exchanger – pos. 4 together with the
motor – pos. 5.
- Remove the metal sheet plate with the motor from the
exchanger.
The hood description:
Picture V:
1 - Vapor drap
2 - Division partition
3 - Connector
4 - Heat exchanger
5 - Motor
The RETIGO Company recommends regular clea-
ning and maintenance of the appliance by a authorized
service company. Excessive wear and tear and possible
damage to the appliance can be prevented only by re-
gular checks of the device and its cleaning.
Preventive service check must be performed after one
year of usage.
Picture VI:
1 - Service openings
Wash all the washable parts (grease filters, steam trap,
division partition) and the inside of the hood with warm
water mixed with detergent. Place the heat exchanger
to the position depicted in picture II. Insert detergent
into the exchanger through the three designated ope-
nings (see picture 5.) and leave it there for 15 minutes.
After that, rinse the exchanger with hot water. Repeat
this procedure until the exchanger is clean.
Picture 5 - Service openings
Let all the parts dry and then reassemble them.