Refer to the system’s full instruction manual for detailed programming
1. Open the battery compartment cover using a flat-bladed screwdriver and
remove the activation strip.
2. Self-testing will commence once the battery activation strip is removed.
Flashing continuously = self testing state. Flashing once indicates that
movement is detected.
3. Fit the detector in a position that will cover your desired protection area,
orientation as per diagram opposite.
4. To test, walk in front of the detector - the LED should illuminate.
When in its working state, if the detector is triggered more than twice in
3 minutes, it will enter into power saving (sleep mode). If no movement
is detected within the next 3 minutes, the detector will return to normal
working mode.
1. Slide down the battery compartment cover using a flat-bladed
screwdriver and remove the activation strip.
2. Remove one side of the double-sided tape and fix the tapes to the
back of the Magnet and Transmitter.
3. Remove the paper strips and mount the magnet on the door and the
transmitter on the door jamb (small triangles adjacent to each other)
with less than a 6 mm separation between the two. When opening the
door a small red indicator lights up briefly, this indicates that the
Transmitter has sent the signal to the Control Panel.
The system can be quickly disarmed by holding the RFID Tag to the RFID
reader.
II. Installing a Door/Window Contact
III. Installing a Wireless PIR
IV. Remote Control Operation
V. RFID Tag Operation
1. Press the Arm Button on the Remote Control
2. The Control Panel will sound every 2 seconds to indicate that it is armed,
allowing 30 seconds to exit the premises.
3. The sound will intensify in tempo for the last 15 seconds to warn that
system activation is imminent.
www.responseelectronics.com
Response Electronics Ltd.,
Roman House, Lysons Avenue, Ash Vale, Surrey, GU12 5QF
email: [email protected]
