I. Installing the Control Panel
1. Carefully remove the battery cover at the back
of the unit using a flat-bladed screwdriver.
2. Plug the power socket into the unit and Power
Supply/plug into a suitable 13 amp socket.
3. Insert a standard size SIM Card (with credit) into the SIM
Card holder.
4. Set the unit’s ‘ON/OFF’ Switch to ‘ON’.
5. Refit the battery cover, ensuring the power supply cable
sits within the channel and exits through the top of the
battery compartment.
6. The GSM indicator (LED) will flash once every second for a short period and
will then flash once every two seconds indicating that the GSM signal has
been found. You can now register your mobile phone to the Control Panel.
If the LED flashes every second (GSM signal not found) power down the
Control Panel, remove the SIM Card and wait 30 seconds. Insert the SIM
Card again and allow 1 minute for the signal to be found, indicated by
a flash once every 2 seconds.
7. Follow steps II to IV to install/set-up the accessories.
1 x Control Panel
1 x PIR Motion Detector
1 x Door/Window Contact
2 x Remote Controls
2 x RFID Tags
1 x AC/DC Adapter
All Batteries & Fittings
Instruction Manual
Kit Contents:
a. Read the instructions thoroughly
b. Remove all the contents from their packaging
c. Have a flat-bladed screwdriver to hand
d. Consider the most appropriate positioning
of
the Control Panel and each Accessory
Note:
The Accessories are pre-programmed to
the Control Panel for ease of installation
Prior to setting up your System:
O
FF
O
N
MiGuard is a trademark of Response Electronics Limited
