12
1. Strictly observe the minimum distance between hood and hob.
2. Clean the surrounding of the installation area before you install the appliance so
the appliance will not extract any dust or construction waste.
3. The exhaust hose must not run in the same air duct as gas tubes, hot air tubes et
cetera.
4. Lead away the exhaust hose from the hood as straight as possible.
5. The proper maximum bending angle outwards is 120
0
.
6. Check with a level if the appliance is horizontally positioned while installing and
after having installed it.
Installation
of the hood
NOTICE!
Use carbon filters in recirculating mode only.
Содержание CH 22035 IXA
Страница 12: ...12 Abb 1 ...
Страница 39: ...10 fig 1 Extractor hood components ...
Страница 56: ...27 10 TECHNICAL DATA Technical data you can find on the Data sheet attached to this manual ...