© RESOL 07089
VA32.monen.ind
d
| 4
RESOL VA32
K
VS
values for F3L Rotodiv.
1. Installation advice
The installation of the valve must be carried out correspon-
ding to the approved technical regulations. Rests of sealing
material and rests of hemp must not get into the valve body.
In order to avoid blocking of the valve ball, the following
advice has to be considered and all solder, brazing or welding
processes near the valve are to be avoided.
Important advice
In order to attain the maximum operating safety and relia-
bility, it is recommended to flush the system and to insert
an appropriate strainer (0,65 µm) in front of each valve (see
installation scheme).
3. Change of flow direction
Change of flow direction A<>AB to AB<>B when the relay
is in rest position.
• Unscrew green housing cover.
• Unscrew sink screw and remove the actuator. Set the ro-
tary slide to the desired basic position (displace the lens
head screws by 90 °).
• Attach the actuator (until it locks) and tighten screw after
the mounting has been finished. Fasten the cover with the
screws. Functional control.
Mounting and demounting
of valve and actuator
Change of flow direction
4. Dimensions
2. Installation position
The valve can be mounted in any position, but not with the
actuator to the bottom. In order to use the hand operation
+/- 90 °, a cable loop of approx. 25 cm has to be arranged
during the electrical connection. In order to have enough
space to carry out maintenance work, a distance of at least
100 mm from the wall or the device respectively has to be
kept.
A
B
AB
A
B
AB
