Guide to ReplayTV
16
Connecting the IR blaster
Use the IR blaster if your satellite receiver or cable box does not support serial cable.
1. Locate the infrared detector on your cable box or satellite receiver.
The infrared emitter at the end of the IR blaster must be placed directly over the infrared
detector on your cable box or satellite receiver. The infrared detector receives the signals
from the remote control.
If the detector on the unit is not labeled, you can usually find it behind a dark, nearly
opaque, plastic area on the front of the unit.
If the infrared detector on the unit is not labeled, follow these steps:
a.
Refer to the owner’s manual of your cable box or satellite receiver. It may be
shown there.
b.
Look for an area of dark, nearly opaque plastic on the front of the unit. If you find
this area, look closely into it. You may be able to see the infrared detector behind
it. If it’s visible, you should see a small square frame with a reddish area in the
center. This is the infrared detector. If you see the detector, skip to “Connect and
affix the IR blaster.”
c.
Shine a flashlight through the dark plastic area on the front of the unit. If you see
the infrared detector, skip to “Connect and affix the IR blaster.”
d.
Using the remote control for your cable box or satellite receiver, turn the power on
and off. Don’t use the ReplayTV remote control.
e.
With the remote control in one hand, place the other hand over one section of the
front of the unit.
Содержание RTV4040
