Renson Endura Twist, Руководство по сборке

Страница: 54 / 92

54
Endura
®
Twist
en
3.2 • Drilling holes for a hidden anchoring
Always use the drill template (that can be found in this manual) to determine the drill positions.
Fold the template on the
folding-line.
Put the template over the
edge of your device and
place it near a partition.
Please make sure your
template matches nicely with
the edge of the device and
mark the centre point of the
drill position(s).
The template offers 5
possible drill positions per
partition.
Remove the template and
drill (dia 6.5) on the marked
positions, through all the
layers of the transparent PVC
upper profile.
➌
Drill at least once through each partition (check on the window
frame).
PLEASE NOTE:
Always use a drill bit with a diameter of 6.5.
Always use a sufficiently long bit so that the unit is
drilled through fully.
+ 15 mm
+ 15 mm
Ø 6,5
➌
➊
Ø 20 mm
• Doorboor enkel de bovenste wand van het transparante PVC-profiel!
• Perforez uniquement la paroi supérieure du profil transparent en PVC !
• Durchbohren Sie nur die obere Wand von dem transparenten PVC-Profil!
• Drill only through the top layer of the transparent PVC-profile!
Verzonken verankering / Ancrage dissimulé /
Verdeckt montierten Verankerung / Hidden anchoring
➋