Installation Guide RN5000US
46
seal, as all of this hardware is necessary to ensure proper grounding and a
weather-tight seal.
4) Check the enclosure seal on the inside of the cover to ensure it is undamaged
and in the correct position.
5) Carefully position the cover on the front of the Digiwatts unit so that the four
holes in the cover are aligned correctly with the four threaded holes in the case.
6) While holding the cover in place, carefully insert the four machine screws with
lock washer, through the holes in the cover into threaded holes in the case and
turn them until they are finger-tight.
Be careful not to cross-thread any of the
screws. Do not use power tools to start the screws.
7) Verify that the cover is in the correct position and that the seal is in place
between the case and the cover.
8) Tighten the cover screws.
Figure 5-8 Closing the Digiwatts unit
