Renkus-Heinz IC Live Gen 5, Руководство пользователя

Страница: 6 / 16

IC L ive
Users Manual
6
To join IC Live modules into a dual or triple array, you will use the included ICL-
F-KIT-UP joining kits. Each kit contains
two heavy metal joining plates.
The first assembly step for a dual is to remove the top of both modules. To
remove the top, remove the eight machine screws from each side of the cabinet
and lift the end piece and its mounting brackets out of the cabinet.
Align the two modules to be joined so that the top of the lower one and the bot-
tom of the upper one are close to one another, say 4” (10 cm) apart.
The next step is to install the two joining plates They will be packed with the
hardware.
Use the mounting bracket machine screws removed above to install the two joining plates .Tighten the screws
lightly. The joining plates need to be a little loose to slide into the other cabinet.Each module has a CAT5 cable and
power cable inside that must be connected to the RJ45 connector and power connector in the other module.
The mounting hinge kit for the array should also be attached
at this point. Attach the heavy joining plates from the hard-
ware package to the rear of the cabinet using the machine
screws provided. A mounting plate that attaches between
two modules of a dual or triple array is double the size of a
mounting plates that attaches to the ends, as shown at left.
Tighten the screws loosely to allow a little movement while
joining the two modules.
Note that the holes in the mounting bracket must be facing
down to hang on the wall bracket. Align the two modules
and slide them together, making sure the holes in the heavy
joining plates align with the holes in the modules. Install the
remaining screws into the joining plates and tighten all the
screws. The assembly is now complete.
If you are making a triple array, repeat the procedure to join
the ICL-FR-LM module to the other two modules.