Renkus-Heinz IC Live Gen 5, Руководство пользователя

Страница: 7 / 16

7
IC L ive
Users Manual
Address Number Verification
Next is to verify that the Slave modules are properly identified. The settings were set at the factory, but it’s always a good
idea to check them. This is accomplished with the dip switches located on the rear of each module. Set the switches in ac-
cordance with the illustrations shown below.
The Master module (ID 0 in RHAON II) is on the bottom by default and the other modules will be Slave IDs 1 and 2 in ascend-
ing order. However, the Master and Slave ICL-F modules can be swapped. For example, the Master may be on top to allow
for different cable drop placement. The dipswitch ID settings on the Slaves must match the column order in RHAON II and
both must match the vertical order of the modules. Refer to the section on Column Ordering in the RHAON II User Manual.
If power was connected to the Array before setting the dip switches, it will need to be disconnected and reconnected before
the dip switch settings will take effect.
SLAVE #1
1 2
O
N
SLAVE #2
1 2
O
N
Slave ID
Switches
and Legend