ADDRESS NUMBER VERIFICATION
Iconyx steerable column loudspeakers are digitally controlled and each 8-channel module must have a separate and distinct address num-
ber. The address number for each module is set using a Binary coding system and 8 on/off dip switches. The switches are located behind
each module’s rear access plate.
The switches are set at the factory based on the size
and quantity of steerable column loudspeakers ordered.
You may want to check and record these settings before
installing the loudspeakers. It is a lot easier to do it now
than it will be after the loudspeakers are installed.
2. Remove the access plate and locate the Address
switches. Each 8-channel module will have an access
plate.
Notice that there are 8 orange on/off Dip switches. The
switches are “on” when set to the position closest to the
numbers and “off” when set to the other position.
Common practice is to number the 8-channel modules
consecutively starting at 01 with the bottom module. In
an ICL-F-DUAL, for example, the bottom module would
be 01 and the one on top of it numbered 02. If the sys-
tem had two ICL-F-DUAL’s, the second ICL-F-DUAL
would have its modules labeled 03 and 04 with number
03 being the bottom module.
The switch settings for modules 1 to 50 are shown to the
right.
IC Live Users Manual, ICL-F & ICL-F-DUAL
7
